ISO 9001 & ISO 13485 Certified Tangxia, Dongguan · China

Springs

Compression springs · custom coils · wire forms

Spring Steel · Stainless ConsumerAppliances

Springs are a small part of what we run, and this page says so rather than pretending otherwise. We are a turned-parts factory: the bulk of our work is inserts, nuts, shafts, washers, bushings and non-standard parts. Springs come up alongside that work, usually because a customer needs a few thousand of them and would rather buy the whole assembly from one supplier than place a second order.

For simple compression springs, coils and wire forms, we are happy to quote. For anything that depends on precise load rates, fatigue life or tight spring-back tolerances, a dedicated spring maker with purpose-built coiling equipment is the right supplier — and we would rather tell you that at the quotation stage than take an order we cannot make well.

What We Can Quote

Simple compression springsRoutine coils where the load requirement is not critical.
Custom coilsCoiled to the dimensions on your drawing.
Wire formsBent and formed wire parts, including simple hooks and loops.
Low to moderate volumesA few thousand pieces, typically alongside another turned part.
Spring steel and stainlessIn the wire sizes our equipment can handle — send the wire diameter and we will confirm.
Assembly co-supplySprings supplied together with the turned parts they fit, on one shipment.

Where we are the wrong supplier

Being clear about this saves both of us time. We are not the right choice when:

· the spring has a specified load or rate that has to be held within a tight band;
· the application needs a documented fatigue life or a high cycle count;
· the part needs grinding, shot-peening or preset operations;
· the volume is very high, where dedicated coiling equipment wins on both price and consistency;
· the geometry is anything other than a straightforward coil or wire form.

If your requirement falls into one of those, say so and we will tell you straight away — there is no benefit to either of us in quoting work that belongs with a specialist.

Spring Enquiry — What to Send

Wire diameterThe wire size the part is coiled from
Outside or inside diameterWhichever your design is based on
Free lengthThe unloaded length of the spring
Solid heightThe fully compressed length, if it matters
Number of coils and endsClosed, open, ground or plain ends
Load requirementState it if you have one — and tell us how tight it is, since that is what decides whether we are the right supplier
MaterialSpring steel, stainless, or the grade on your drawing
QuantityPer order and per year — the annual figure decides whether this belongs with us or a specialist
Tight load tolerances belong with a spring specialist. If the spring has to hold a specific force, tell us the number and the acceptable band. We will give you a straight answer rather than a quote that leads to a rejected batch.

Springs — Common Questions

Do you manufacture springs?
We quote simple compression springs, coils and wire forms, usually alongside a turned part the customer is already ordering. Springs are a small part of our business, not our speciality, and we say so.
Do you hold load rate specifications?
Only where the requirement is not critical. If the spring has to hold a defined force within a tight band, a dedicated spring manufacturer with purpose-built equipment is the better supplier and we will tell you so.
What wire sizes can you handle?
Send the wire diameter, the coil diameter and the free length and we will confirm whether it is within what our equipment can run.
What information do you need for a spring quote?
Wire diameter, outside or inside diameter, free length, solid height, number of coils, end type, material, load requirement if there is one, and the quantity. The list is on this page.
Can you supply springs together with the turned parts?
Yes — if you are ordering a turned part that the spring fits into, we can supply both on one shipment. That is usually why a spring enquiry reaches us in the first place.
Have a part drawing? Get a quote within one working day. Send a STEP, DWG, DXF or PDF file — or post us a sample. You will hear back from the engineers who will actually make the part. Request a Quote →