Shafts and pins are unforgiving parts. A washer can be a few hundredths out and still work. A shaft that is out of round, or whose second diameter does not run concentric with the first, turns into a vibration, a bearing failure or a rejected assembly.
We turn them in a single setup wherever the geometry allows, so concentricity holds across every diameter rather than being re-established between operations. Where a part is too long to hold that way, we will tell you which dimension is at risk and how we plan to control it.
Pin & Shaft Work We Run
Shaft & Pin Specification
| Machining tolerance | ±0.01 mm standard, held on the dimensions you mark as critical |
|---|---|
| Concentricity | Controlled across tandem diameters machined in the same setup |
| Machining diameter | Ø1–40 mm daily range, up to Ø46 mm by process review |
| Max workpiece length | 1.5 m on the horizontal lathes |
| Straightness | Discussed at quotation for long, slender parts — send the length-to-diameter ratio and the straightness you need |
| Materials | Stainless 303/304/316 · carbon steel 20#/45#/12L14 · brass · aluminum 6061-T6/6063 |
| Ends and features | Chamfers, radii, centre holes, threads, knurls, cross-drilling and flats |
| Heat treatment | Arranged to your specification where the part needs it; hardness testing can be supplied |
Sending us the fit, not just the diameter
A shaft is only correct in relation to the bore it goes into. If you tell us the mating part — a bearing, a bushing, a housing — and the fit you need, we machine to it and check it. If you send a bare diameter with no tolerance callout, we will ask, because a shaft that measures right and fits wrong is the most expensive kind of correct.
For long, slender parts, the length-to-diameter ratio decides whether ordinary turning or Swiss-type turning is the better route. Send us the geometry and we will quote the process that holds the part, rather than the one that is easiest to quote.


