ISO 9001 & ISO 13485 Certified Tangxia, Dongguan · China

Sleeves, Bushings & Tubes

Bushings · sleeves · spacers · tube fittings

Brass · Bronze · Steel MachineryHydraulics

On a bushing, the bore is the part. Outside diameter, wall thickness and concentricity all exist to put the bore in the right place with the right fit — and a bushing that is dimensionally correct but has a bore that is out of round will wear, rattle or seize.

We turn bushings, sleeves and spacers from solid bar and from tube, in brass, bronze, steel and stainless. Bores are held to ±0.01 mm where the drawing calls for it, and press-fit diameters are quoted against the housing they go into rather than as a bare number.

Sleeve & Bushing Work

Plain bushingsPress-fit and slip-fit, with controlled bore and OD.
Flanged bushingsTurned with an integral flange and a square shoulder.
Grooved bushingsOil or retaining grooves, internal or external.
Sleeves and linersThin-wall parts where wall thickness uniformity matters.
Spacers and standoffsCut to length, square and deburred.
Tube fittings and insertsTurned bodies with threads, cross-holes or secondary milling.

Bushing & Sleeve Specification

Bore tolerance±0.01 mm standard, held on the dimensions you mark as critical
ConcentricityBore and outside diameter related in a single setup where geometry allows
Wall thicknessDiscussed at quotation for thin-wall parts, since wall uniformity drives distortion
Machining diameterØ1–40 mm daily range, up to Ø46 mm by process review
MaterialsBrass C3604/H62/H59 · bronze · steel 20#/45#/12L14 · stainless 303/304/316 · aluminum
FinishingSandblasting, zinc and nickel plating, blackening, passivation, polishing
VolumePrototypes from 5 pcs · MOQ 100 pcs per part number

Sending us the housing, not just the bushing

Press-fit parts live or die on the interference between two components, and we only see one of them. If you tell us the housing bore, the material it is made of and the retention you need, we can hold the right interference and check it. Give us a bare outside diameter and we will machine exactly what you asked for — and it may or may not press in.

Thin-wall bushings are the other place where an early conversation saves money: below a certain wall thickness, distortion during machining becomes the dominant problem, and a small change to the wall, the material or the tolerance is often the difference between a part that works and a part that is expensive to make.

Sleeves, Bushings & Tubes — Common Questions

Can you hold a press-fit diameter?
Yes — tell us the housing bore, its material and the retention you need, and we machine and inspect to that interference rather than to an isolated diameter.
How thin a wall can you machine?
It depends on the diameter, the material and the length. Thin walls distort during machining, so send the dimensions and we will tell you what is achievable before you commit.
Do you make grooved bushings?
Yes — internal or external oil grooves, retaining grooves and flange reliefs are all turned features we run.
What material is best for a bushing?
Bronze for dry running and load capacity, brass for general use, steel where the part carries structural load, and stainless where corrosion matters. Tell us the shaft material and the running conditions and we will recommend one.
Are the parts deburred?
Yes, including bore edges — a sharp bore edge damages the shaft it is pressed onto.
Have a part drawing? Get a quote within one working day. Send a STEP, DWG, DXF or PDF file — or post us a sample. You will hear back from the engineers who will actually make the part. Request a Quote →